Tazer Z-Locker Controller from Z Automotive is a simple adapter to retain the factory locker switches, dash messages, warnings and will even set off the “service locker” message if your aftermarket locker is faulty or gets disconnected. Plugin using your factory Rubicon harness to your aftermarket E-Lockers or Air Lockers.
Z Automotive uses watertight connectors, a potted design, and automotive-grade internal components. These are made to last in the harsh Jeep undercarriage environment.
One end of the adapter plugs into the 4 pin factory harness, providing the required signals to keep the Rubicon locker control logic satisfied. The other end is a 2 pin connector which will output 12 Volts to engage your E-Locker or Air Locker solenoid.
If you have a Tazer JL Mini (or Tazer JL), you can use lockers at your command in 4HI and 2WD modes as well.
The output connector is an industry-standard part that will plug into most E-Lockers. Use the optional locker extension if you have a different mating connector or need to run longer wires; usually needed for Air Locker installations. This extension gives a total reach from the factory locker location of over 7.5 feet.
- Product Category:
- Tools
